Learn about removing and replacing the workflow accelerator card.
Turn the printer power off
Disconnect the power cable.
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
If the part is damaged and cannot be cleaned, use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Part number |
Part description |
---|---|
1M0Q5A |
HP LaserJet Workflow Accelerator Card |
#2 Phillips screwdriver with a magnetic tip and a 152 mm 6 in shaft length
Turn the printer power on
Connect the power cable.
Use the power switch to turn the power on.
Print any pages necessary to make sure the printer is functioning correctly.
Follow these steps to remove the formatter cover.
Follow these steps to remove the workflow accelerator.
ESD sensitive part.
Follow these steps to unpack the replacement assembly.
Follow these steps to install the workflow accelerator.
ESD sensitive part.
Follow these steps to install the formatter cover.