hp-support-head-portlet

- ${title}
hp-contact-secondary-navigation-portlet

- ${title}
hp-share-print-widget-portlet

- ${title}
hp-concentra-wrapper-portlet

- ${title}
HP Color LaserJet M855 and HP Color LaserJet Flow MFP M880 - Removal and replacement: Fuser
This document provides the procedures to remove and replace the fuser for the HP Color LaserJet Enterprise M855 and HP Color LaserJet Enterprise Flow MFP M880.
Mean time to repair: 5 minutes
Service level: Basic
Before performing service
Turn the printer power off
-
Disconnect the power cable.
Warning:To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
The fuser might be hot. HP recommends waiting 30 minutes after turning off the product power to let the fuser cool.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Fuser Kit Part Numbers |
|
---|---|
C1N54A (110V) |
Fuser kit with instruction guide (110V) |
C1N58A (220V) |
Fuser kit with instruction guide (220V) |
Required tools
-
No special tools are required to install this kit.
After performing service
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
Print a configuration page to make sure that the printer is functioning correctly.
Remove the fuser
Follow these steps to remove the fuser.
Unpack the replacement assembly
Follow these steps to unpack the replacement assembly.
Install the replacement fuser
Follow these steps to install the replacement fuser.
hp-feedback-input-portlet

- ${title}
hp-feedback-banner-portlet

- ${title}
hp-country-locator-portlet

- ${title}

hp-detect-load-my-device-portlet

- ${title}
hp-hero-support-search

- ${title}