solution Contentsolution Content

HP DeskJet, ENVY 6000, 6400 Printers - Replacing Input Tray

This document is for HP DeskJet Plus Ink Advantage 6075, 6078, 6475, 6476, 6478, ENVY 6010, 6020, 6022, 6030, 6032, 6052, 6052e, 6055, 6055e, 6075e, 6452e, 6455e, 6475e, ENVY Pro 6420, 6452, 6455, and 6458 All-in-One printers.
How to properly replace a broken input tray.

Replace the broken or defective input tray

To replace the input tray, disconnect the power cable, remove the defective input tray, and install a new one.
  1. Turn off the printer, and then disconnect the power cord from the printer.
    The printer must be disconnected from power to avoid damaging the printer power module.
  2. Set the printer on its back.
    Prevent the Automatic Document Feeder (ADF) or scanner lid from opening abruptly when you tilt the printer vertically.
    Setting the printer on its back
    Setting the printer on its back
  3. Slide the input tray up.
    Sliding the input tray up
  4. When the tray stops, press outward on the tray retainer to provide enough clearance for release, and remove the tray from the printer.
    Releasing the tray retainer
  5. Unpack the new input tray, part number: 4LW49-60004 or 4LW49-60040.
    Upacking new input tray
  6. Align the new input tray to both sides and push the input tray down to insert it. Release the stop-catch slightly, if needed.
    Aligning the new input tray and releasing the stop-catch
  7. Slide the input tray fully down to complete tray installation.
    Sliding the new input tray down
  8. Set the printer onto a hard, even surface that is clear of all obstructions.
    Setting the printer on a hard surface
  9. Open and close the new input tray to ensure it works properly.
  10. Reconnect the power cord, and then turn on the printer.