hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information

    Fix and resolve Windows 10 update issue on HP Computer or Printer. Click here

    Information
    Create an HP account today!

     Connect with HP support faster, manage all of your devices in one place, view warranty information and more. Learn more​

hp-concentra-wrapper-portlet

Actions
Loading...

HP LaserJet Pro M402, M403, MFP M426, MFP M427 - Removal and replacement: Optional 550-sheet accessory tray

Introduction

This document provides the procedures to remove and replace the optional 550-sheet paper feeder.

Before performing service

Turn the printer power off
  • Disconnect the power cable.
      warning:
    To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Optional 550-sheet paper feeder part number
C5F697–69001
Optional 550-sheet paper feeder (optional Tray 3)

Required tools

  • No special tools are required to remove this part.

After performing service

Turn the printer power on
  • Connect the power cable.
  • Use the power switch to turn the power on.

Post service test

Make sure that the printer initializes to a Ready state.
Print a page from the optional Tray 3 to make sure that the paper feeder is functioning correctly.

Step 1: Remove the optional 550-sheet feeder Tray 3

  1. Carefully lift the printer off of the paper feeder assembly.
    Figure : Remove the printer

Step 2: Unpack the replacement optional paper feeder

Unpack the replacement part from the packaging.
note:
HP recommends responsible disposal of the defective part.
Recycle and unpack
Figure : Recycle and unpack

Step 3: Install the optional 550-sheet feeder Tray 3

  1. Remove the orange shipping tape.
    Figure : Remove shipping tape
  2. Carefully place the printer on the paper feeder assembly.
    Figure : Install the printer
  3. Pull Tray 3 out of the paper feeder assembly to remove it.
    Figure : Remove Tray 3
  4. Adjust the Tray 3 sliding paper guides.
    Figure : Adjust the paper guides
  5. Load paper in Tray 3.
    Figure : Load paper
  6. Slide Tray 3 into the paper feeder assembly to install it.
    Figure : Install

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag Croatia

hp-detect-load-my-device-portlet

Actions
Loading...