Error:

Javascript is disabled in this browser. This page requires Javascript. Modify your browser's settings to allow Javascript to execute. See your browser's documentation for specific instructions.

hp-support-head-portlet

Actions

HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions

hp-share-print-widget-portlet

Actions

hp-concentra-wrapper-portlet

Actions

HP EliteBook 2570p Notebook PC - Removing and Replacing the Service Door

Introduction

Minimum skill level

Parts required

Service door removal instructions

Service door replacement instructions

Parts return

This document pertains only to HP ProBook 4446s Notebook PC with the following case design:

Introduction

This document is provided to assist in removing and replacing the service door for the HP EliteBook 2570p Notebook PC.

Minimum skill level

The end user requires no hardware-specific training to replace the defective part. The end user should have familiarity with system hardware and software requiring repair.

Parts required

note:
Part numbers are subject to change.

The replacement part number will vary depending on the service door that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP.

Description	Part Number	Requires Return
Service cover	685400-001 (Modified)	Yes

note:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labeled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labeled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

Service door removal instructions

To view a video demonstrating the procedure for removing/replacing the battery, click here to view the HP Services Media Library and then click on Remove/Replace videos. On the new window, select Battery from the menu on the upper left hand side of the screen.

Review the safety considerations before performing the steps listed below by clicking on the following link:

Click here to view the precautions.

caution:
Failure to comply with the precautions could result in damage to the product or loss of data.

note:
The following video depicts a specific configuration of the notebook. The same removal and replacement procedures apply to all configurations of the notebook.

Step	Procedure	Instruction
1	Remove the battery.	Click here for instructions on how to remove the battery.
2	Slide the service door release latch (identified with a service door icon) into the release position to partially eject the service cover.
3	Slide the service door towards the front of the notebook.
4	Lift the service door and remove.

Service door replacement instructions

Step	Procedure	Instruction
1	Align and place the service door into position on the base enclosure.
2	Slide the service door toward the rear of the notebook until it is properly seated and the service door release latch clicks.
3	Slide the service door release latch (identified with a service door icon) into the locked position.
4	Replace the battery.	Click here for instructions on how to replace the battery.