hp-support-head-portlet

動作
正在載入...
HP 顧客貼心服務 - 知識庫

hp-contact-secondary-navigation-portlet

動作
正在載入...

hp-share-print-widget-portlet

動作
正在載入...

hp-concentra-wrapper-portlet

動作
正在載入...

HP Compaq 8200 Elite Small Form Factor PC - Removing and Replacing the Memory

Introduction

This document is provided to assist in removing and replacing the memory for the HP Compaq 8200 Elite Small Form Factor PC.

Minimum skill level

The End user requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

Parts required

注意:
Part numbers are subject to change.
The replacement part number will vary depending on the memory that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP.
Description
Part Number
Requires Return
1GB, PC3-10600, DDR3-1333 MHz, 240-pins,non-ECC, unbuffered DIMM (Dual In-Line Memory Module)
635802-001 (Modified)
Yes
2GB, PC3-10600, DDR3-1333 MHz, 240-pins,non-ECC, unbuffered DIMM (Dual In-Line Memory Module)
635803-001 (Modified)
Yes
4GB, PC3-10600, DDR3-1333 MHz, 240-pins, non-ECC, unbuffered DIMM (Dual In-Line Memory Module)
585157-001 (Modified)
Yes
注意:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

Summary of instructions

To view a video demonstrating the procedure for removing the memory, click on the link below. Or use the product video listing on the HP Services Media Library (Click here to go to HP Service Media Library), then select Memory from the menu on the upper left hand side of the screen.
Click here to view the memory removal video (right-click on the link to open in a new window/tab).

Memory removal

  1. Review the safety considerations before performing the steps listed below by clicking on the following link:
      敬告:
    Failure to comply with the precautions could result in damage to your product or loss of data.
  2. Rotate the drive cage to the up position.
  3. Push down and out on the memory socket latches to release the memory module.
  4. Pull the memory module up and out of the socket.

Memory replacement

  1. Ensure that the memory socket latches are pushed down and away from the memory socket.
  2. Match the notch on the memory module with the key on the memory socket.
  3. Push the module down firmly into the socket until the latches snap into place and the module is fully seated.
  4. Rotate the drive cage to the down position.

Parts return


hp-feedback-input-portlet

動作
正在載入...

hp-feedback-banner-portlet

動作
正在載入...

hp-country-locator-portlet

動作
正在載入...
國家/地區: 中國香港

hp-detect-load-my-device-portlet

動作
正在載入...