Error:

Javascript is disabled in this browser. This page requires Javascript. Modify your browser's settings to allow Javascript to execute. See your browser's documentation for specific instructions.

hp-support-head-portlet

Actions

HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions

hp-share-print-widget-portlet

Actions

Information

Learn how to upgrade to Windows 11
Windows 11 Upgrade Guide

Information

Create an HP account today!
Connect with HP support faster, manage all of your devices in one place, view warranty information and more. Sign up for an HP account

Feedback

hp-concentra-wrapper-portlet

Actions

HP Color LaserJet Enterprise M652, M653, Managed E65050, E65060, E65150, E65160 and HP Color LaserJet Enterprise MFP M681, M682, Managed MFP E67550, E67560, E67650, E67660 - Install accessory: Trusted platform module (TPM)

Learn how to install the trusted platform module (TPM).

Mean time to repair: 5 minutes

Service level: Basic

Important:

When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Before performing service

Turn the printer power off.
Disconnect the power cable.

Warning:
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.

Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts

Part information
Part numbers	Part description
F5S62-61001	Trusted platform module (TPM)

Required tools

No special tools are needed to remove or install this assembly.

After performing service

Turn the printer power on

Connect the power cable.
Use the power switch to turn the power on.

Post service test

Make sure that the printer initializes to a Ready state.

Print a configuration page to make sure that the printer is functioning correctly.

Remove the formatter cover

Follow these steps to remove the formatter cover.

Unscrew two thumbscrews (callout 1), and then slide the formatter cover (callout 2) away from the printer to remove it.

Tip:
Reverse the removal steps to install the assembly.

Remove the formatter cover

Remove the TPM

Follow these steps to remove the TPM.

CAUTION:

ESD symbol

ESD sensitive part.

The TPM is available as an accessory for the M652/M653/M681/M682 models, and it is included as a standard component for the E65150/E65160/E67650/E67660 models. If your printer does not have a previously installed TPM, proceed to the next section.

Locate the TPM card on the formatter, and then pull it straight off of the formatter to remove it.

Remove the TPM

Remove the accessory from its package

Follow these steps to remove the accessory from its package.

Save all packaging for recycling.
For complete information about HP recycling programs, go to http://www8.hp.com/us/en/hp-information/environment/product-recycling.html.

Install the TPM

Follow these steps to install the TPM.

CAUTION:

ESD sensitive part.

Note the location on the formatter where the TPM will be installed.

TPM location
Align the connector on the TPM (callout 1) with the connector on the formatter (callout 2).

Note:
The TPM can only be installed in one direction on the formatter.

Align the connectors
Push the TPM onto the formatter to install it.

Important:
Press on the top part of the TPM to ensure it is fully seated in the connector.

Install the TPM