Error:

Javascript is disabled in this browser. This page requires Javascript. Modify your browser's settings to allow Javascript to execute. See your browser's documentation for specific instructions.

hp-support-head-portlet

Actions

HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions

hp-share-print-widget-portlet

Actions

Information

Apache Log4j Update
Please see this document here for current information regarding the Apache Log4j vulnerability.

Information

Need Windows 11 help?
Check documents and videos on compatibility, FAQs, upgrade information and available fixes. Windows 11 Support Center

Feedback

hp-concentra-wrapper-portlet

Actions

Remove and Replace the Graphics Card for OMEN by HP Obelisk 875-0xx, 870-xxx Desktop PCs

This document is for OMEN by HP Obelisk 875-0xx Desktop PC and OMEN by HP 870-xxx Desktop PC.

Before you begin

Turn off the computer. Disconnect the Ethernet or modem cable. Disconnect the power cord.
Transfer the computer to a clear, flat, stable work surface over a non-carpeted floor.
HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
Do not remove a component from its protective packaging until you are ready to install it.

warning:
Before starting, power off the computer and wait for components to cool before starting these procedures.

caution:
This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a non-carpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

caution:
Procedures in this document are provided by HP for qualified service agents and as a courtesy to its customers. Servicing internal components increases the risk of damaging the computer which might not be covered under warranty. Understand the risk and refer to the product's warranty before attempting to service the computer.

Removing the graphics card

Remove the graphics card.

Step 1 Remove the access panel. For instructions on removing the access panel, go to How to Replace the Access Panel for OMEN by HP Obelisk 875-0xx Desktop PC and OMEN by HP 870-xxx Desktop PC.
Step 2 Remove the P1 Phillips-head screws that secure the graphics card to the top of the expansion slot on the chassis. note: The number of screws to remove depends on the graphics card.
Step 3 Depending on the graphics card installed, push down (or push sideways) the retaining lever on the expansion slot on the motherboard.
Step 4 Grasp the top of the graphics card on either side and gently move it from side to side...
...and then lift it from the expansion slot.

Replacing the graphics card

Replace the graphics card.

Step 1 Grasp the top of the graphics card on either and insert the graphics card aligning the golden fingers with the expansion slot on the motherboard.
Step 2 Using minimal force, press down until the retaining lever clicks into place.
Step 3 Replace the single P1 Phillips-head screw that secures the graphics card to the top of the expansion slot on the chassis.
Step 4 Replace the access panel. For instructions on replacing the access panel, go to Removing and Replacing the Access Panel for OMEN by HP Obelisk 875-0xx Desktop PC and OMEN by HP 870-xxx Desktop PC.

hp-feedback-input-portlet

Actions

hp-feedback-banner-portlet

Actions

hp-country-locator-portlet

Actions

Country/Region: Hong Kong SAR

hp-detect-load-my-device-portlet

Actions

hp-hero-support-search

Actions

Examples: "DeskJet 2130 paper jam", "EliteBook 840 G3 bios update"