HP Photosmart e-All-in-One (D110a and D110b) Printers - Setting up the All-in-One (Hardware)

1. Lower both the paper tray and the cartridge door.
   Εικόνα : Lower the paper tray

   
2. Remove all packing material and protective film from the product.
   Εικόνα : Remove the packing material

   
3. Close the cartridge door.
   Εικόνα : Close cartridge door

   

σημείωση:

Do not connect the USB cable.

1. Connect the power adapter to the back of the product.
2. Connect the power cord to the power adapter.
3. Connect the other end of the power cord to an alternating current (AC) power outlet.

1. On the product control panel, press the Right Arrow () to select your language, and then press OK.
2. Press the Right Arrow () to select Yes, and then press OK.
3. Press the Right Arrow () to select your country/region, and then press OK.
4. Press the Right Arrow () to select Yes, and then press OK.

1. Open the cartridge door. Make sure the carriage moves to the center. If it does not move to the center, turn the product off, and then turn it back on again.
   Εικόνα : Open the cartridge door

   
2. Remove the cartridges from their packaging, and then remove the pink protective tape from both cartridges.

     προσοχή:

   Do not touch the copper-colored contacts or re-tape the cartridges.

   Εικόνα : Remove the pink tape

   Εικόνα : Do not touch contacts

3. Hold the cartridges with the label on top.
   Εικόνα : Label on top

   
4. Insert the tri-color cartridge into the left carriage slot and insert the black cartridge into the right carriage slot.
   Εικόνα : Tri-color cartridge in the left slot

   
5. Press the cartridges firmly into the carriage until they snap into place.
   Εικόνα : Insert cartridges until they snap into place

   
6. Close the cartridge door.
   Εικόνα : Close cartridge door

   
7. Press OK to confirm the installation of genuine HP cartridges, when prompted.

1. Pull out the tray extender, and then flip open the paper catch.
   Εικόνα : Pull out tray extender

   
2. Load paper in the input tray with the short edge forward and the print side down. Slide the stack forward until it stops.
   Εικόνα : Load paper

   

   σημείωση:

   Make sure all the paper in the stack is the same size and type and free from rips, dust, wrinkles, and curled or bent edges.

3. Slide the paper-width guide inward until it stops at the edge of the paper.
4. Press OK.

1. Follow the instructions on the control panel display to print the alignment page.
   Εικόνα : Alignment page prints

   
2. Lift the lid.
3. Load the alignment page face down in the front right corner of the glass.
   Εικόνα : Load alignment page

   
4. Close the lid, and then press OK to complete the alignment.