hp-support-head-portlet

Actions
Loading...
Υποστήριξη πελατών HP - Γνωσιακή βάση δεδομένων

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...

hp-concentra-wrapper-portlet

Actions
Loading...

HP Officejet J5700 Series All-in-Ones - Installing Cartridges

Introduction

This document provides information on how to install cartridges in Officejet J5700 Series All-in-Ones.

Installing cartridges

Before you begin, make sure to check the cartridge compatibility for your product.
Purchase replacement cartridges and other supplies from the HP Store or local retailers.

Step one: Install the cartridges

Follow these instructions to install the cartridges:
  1. Press the On button to turn on the product.
    σημείωση:
    The On button is lit when the product is turned on.
    Εικόνα : Pressing the ON button
  2. Open the carriage access door by lifting it, and then wait until the carriage moves to the far right side and the product becomes idle and silent.
    Εικόνα : Lifting up the carriage access door
  3. Remove the protective tape from the new, compatible cartridge.
    σημείωση:
    You can use the link provided at the top of this article to check cartridge compatibility for your product, and to order new cartridges.
      προσοχή:
    When removing the protective tape, do not attempt to remove the copper strip.
      Εικόνα : Removing the protective tape
    1. Protective tape
      προσοχή:
    After the tape is removed, do not touch the copper contacts or the ink nozzles.
      Εικόνα : Contacts and nozzles
    1. Contacts
    2. Nozzles
  4. Hold the cartridge so that the nozzles are down and the contacts are facing the printer, and then slide the cartridge into the carriage.
    • Insert cartridges marked with a triangle into the left carriage slot.
    • Insert cartridges marked with a square or pentagon into the right carriage slot.
    Εικόνα : Sliding the cartridge into the carriage
  5. Push the cartridge forward until it clicks into place.
    Εικόνα : Pushing the cartridge into place
  6. Close the carriage access door.
    Εικόνα : Closing the carriage access door

Step two: Align the cartridges

The product aligns the cartridges every time a cartridge is installed or replaced. Follow these steps to align the cartridges from the control panel:
  1. Make sure letter or A4 unused plain white paper is loaded in the input tray. Then press OK.
    Εικόνα : Pressing the OK button
  2. The product prints a cartridge alignment sheet.
    σημείωση:
    The alignment will fail if colored paper is loaded in the input tray. Load unused plain white paper into the input tray, and then try the alignment again.
  3. Place the alignment sheet on the scanner glass for scanning.
  4. Press OK to begin the alignment.
  5. The product aligns the cartridges. Recycle or discard the cartridge alignment sheet.

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Χώρα/περιοχή: Flag Ελλάδα

hp-detect-load-my-device-portlet

Actions
Loading...