
hp-support-head-portlet

- ${title}
hp-contact-secondary-navigation-portlet

- ${title}
hp-share-print-widget-portlet

- ${title}
hp-concentra-wrapper-portlet

- ${title}
HP Color LaserJet M552, M553, M554, M555, MFP M577, MFP M578, Managed E55040, and Managed MFP E57540 - Removal and replacement: Fuser
This document provides the procedures to remove and replace the fuser.

Mean time to repair: 5 minutes
Service level: Basic
Before performing service
Turn the printer power off
-
Disconnect the power cable.
Warning:To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Part number |
Part description |
---|---|
B5L35-67902 |
Fuser (110V) with instruction guide |
B5L36-67902 |
Fuser (220V) with instruction guide |
Required tools
No special tools are required to install this part.
After performing service
Make sure that the right door is fully closed after replacing the fuser.
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
Print a configuration page to make sure that the printer is functioning correctly.
Remove the fuser
Follow these steps to remove the fuser.
Unpack the replacement assembly
Follow these steps to unpack the replacement assembly.
Install the fuser
Follow these steps to install the fuser.
Reset the supplies counter
Follow these steps to reset the supplies counter.
The procedures in this section are for printers with FutureSmart 3 (FS3) firmware installed only)
hp-feedback-input-portlet

- ${title}
hp-feedback-banner-portlet

- ${title}
hp-country-locator-portlet

- ${title}

hp-detect-load-my-device-portlet

- ${title}
hp-hero-support-search

- ${title}