Error:

Javascript is disabled in this browser. This page requires Javascript. Modify your browser's settings to allow Javascript to execute. See your browser's documentation for specific instructions.

hp-support-head-portlet

Actions

HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions

hp-share-print-widget-portlet

Actions

Information

Need Windows 11 help?
Check documents and videos on compatibility, FAQs, upgrade information and available fixes. Windows 11 Support Center

Feedback

hp-concentra-wrapper-portlet

Actions

HP and Compaq Desktop PCs - Motherboard Specifications, H-Joshua-H61-uATX (Joshua)

Figure : The Joshua motherboard

Motherboard description

Manufacturer's name: Foxconn
Motherboard name: H-Joshua-H61-uATX
HP/Compaq name: Joshua
SSID: 2ADA

Form Factor

uATX: 24.4 cm (9.6 in) x 24.4 cm (9.6 in)

Chipset

Intel H61

Front-side bus speed

5 GT/s (Direct Media Interface)

Processor upgrade information

TDP: Varies by processor
Socket type: LGA 1155

Motherboard supports the following processor upgrades:

Processor	TDP
Intel Core i3-3xxxT (Ivy Bridge) Dual Core	up to 35 W
Intel Core i3-3xxx (Ivy Bridge) Dual Core	up to 55 W
Intel Core i5-3xxxT (Ivy Bridge) Dual Core	up to 35 W
Intel Core i5-3xxxT (Ivy Bridge) Quad Core	up to 45 W
Intel Core i5-3xxxS (Ivy Bridge) Quad Core	up to 65 W
Intel Core i5-3xxxP (Ivy Bridge) Quad Core (onboard graphics not supported)	up to 69 W
Intel Core i5-3xxx (Ivy Bridge) Quad Core	up to 77 W
Intel Core i7-3xxx (Ivy Bridge) Quad Core	up to 77 W
Intel Core i3-2xxx (Sandy Bridge) Dual Core	up to 65 W
Intel Core i3-2xxxT (Sandy Bridge) Dual Core	up to 35 W
Intel Core i5-2xxx (Sandy Bridge) Quad Core	up to 95 W
Intel Core i5-2xxxP (Sandy Bridge) Quad Core	up to 95 W
Intel Core i7-2xxx (Sandy Bridge) Quad Core	up to 95 W
Intel Celeron G4xx (Sandy Bridge) Single Core	up to 35 W
Intel Celeron G5xx (Sandy Bridge) Dual Core	up to 65 W
Intel Pentium G6xx (Sandy Bridge) Dual Core	up to 65 W
Intel Pentium G6xxT (Sandy Bridge) Dual Core	up to 35 W
Intel Pentium G8xx (Sandy Bridge) Dual Core	up to 65 W
Intel Pentium G16xx (Sandy Bridge) Dual Core	up to 55 W
Intel Pentium G20xx (Ivy Bridge) Dual Core	up to 55 W

Memory upgrade information

Dual channel memory architecture
Two 240-pin DDR3 DIMM sockets
Supports the following:
- PC3-10600 (DDR3-1333)
- PC3-12800 (DDR3-1600)
Non-ECC memory only, unbuffered
Supports 1 GB, 2 GB, 4 GB and 8 GB DIMMs
Supports up to 4 GB on 32-bit systems

note:
32-bit systems cannot address a full 4.0 GB of memory.
Supports up to 16 GB on 64-bit systems

note:
Maximum memory shown reflects the capability of the hardware and can be limited further in the operating system.

Video

Intel Graphics Media Accelerator HD Integrated graphics

*Integrated video is not available if a graphics card or an Intel processor ending with “P” is installed.

A processor that supports graphics is required for integrated graphics to be enabled.
Integrated graphics: Intel Graphics Media Accelerator HD (DX10.1)
Either integrated graphics or the PCI Express x16 slot are usable at one time; they are not usable concurrently.
Use of both DVI ports at the same time is supported.

Audio

Integrated IDT 92HD73E Audio

*Integrated audio is not available if a sound card is installed.

Audio codec: IDT 92HD73E
7.1 channel audio
Beats Audio support: yes

Network

LAN: 1000BASE-T

Interface: Integrated into motherboard
Technology: RTL8171FH-CG gigabit Ethernet controller
Data transfer speeds: up to 10/100/1000 Mb/s
Transmission standards: 1000BASE-T Ethernet

Expansion Slots

One PCI Express x16 (Gen2.0)
Three PCI Express x1 (Gen2.0)
One PCI Express x1 Mini Card

I/O Ports and internal connectors

Back I/O ports

Figure : Back I/O ports

USB 2.0: 4

LAN (Ethernet)

DVI-D

DVI-I

Audio center/subwoofer

Audio rear speaker out

Audio side speaker out

Audio line-in

Audio line-out

Microphone

Internal Connectors

1x Front audio connector Mini-PCIE LED
1x Mini-PCIE LED connector
1x LPC debug connector
1x Flash override connector
1x USB 2.0 connector
2x Dual-USB 2.0 connectors
1x USB 3.0 connector
1x Front panel connector
4x Serial ATA connectors
1x One touch reset connector
1x One touch recovery connector
1x BIOS recovery connector
1x Hood sense connector
1x Power supply connector
1x CPU fan connector
1x ATX 12V connector
1x System FAN connector

Jumper Settings

caution:
Do not change any jumper setting while the computer is on. Damage to the motherboard can result.

Clearing the CMOS settings

This motherboard has a jumper to clear the Real Time Clock (RTC) RAM in CMOS.

Turn OFF the computer and unplug the power cord.
Move the jumper to from pins 1-3 (default) to pins 3-5, then move the jumper back to the default position.
Plug the power cord and turn ON the computer.