Printer Specifications for HP Photosmart 7510 e-All-in-One Printer Series

Purchase replacement cartridges and other supplies from the HP Store or local retailers.

• Color Input/Black Render: 300 x 300 dpi
• Output (Black/Color): Automatic

• Color Input/Black Render: 600 x 300 dpi
• Output (Black/Color): Automatic

• Color Input/Black Render: 600 x 600 dpi
• Output: 600 x 1200 dpi (Black), Automatic (Color)

• Color Input/Black Render: 600 x 600 dpi
• Output (Black/Color): Automatic

• Color Input/Black Render: 1200 x 1200 dpi
• Output: Automatic (Black), 4800 x 1200 optimized dpi (Color)

Energy usage drops significantly while in ENERGY STAR mode, which saves natural resources, and saves money without affecting the high performance of this product. This product qualifies for ENERGY STAR, which is a voluntary program established to encourage the development of energy-efficient office products.

ENERGY STAR is a U.S. registered mark of the U.S. EPA. As an ENERGY STAR partner, Hewlett-Packard Company has determined that this product meets the ENERGY STAR guidelines for energy efficiency. For more information, go to www.energystar.gov.

Click here to get the Material safety data sheets (MSDS).

This product is suited for the use of recycled paper according to DIN 19309. Plastic parts over 25 grams are marked according to international standards that enhance the ability to identify plastics for recycling purposes at the end of the product's life.

HP offers an increasing number of product return and recycling programs in many countries and regions, and partners with some of the largest electronic recycling centers throughout the world. HP conserves resources by reselling some of its most popular products. For more information about the recycling of HP products, go to www.hp.com/go/recycle (in English).

For regulatory identification purposes, the printer is assigned a Regulatory Model Number. The Regulatory Model Number for your printer is SDGOB-1021. This regulatory number should not be confused with the marketing name (HP Photosmart 7510 Series) or printer number.

The radiated output power of this device is far below the FCC radio frequency exposure limits. Nevertheless, the device shall be used in such a manner that the potential for human contact during normal operation is minimized. This printer and any attached external antenna, if supported, shall be placed in such a manner to minimize the potential for human contact during normal operation. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm (8 inches) during normal operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance with the instructions, it might cause harmful interference to radio communications. However, there is no guarantee that interference does not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correcting the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect equipment to an outlet on a circuit different from that to which the receiver is located.
• Consult a dealer or an experienced radio/TV technician.

note:

Any changes or modifications to the product that are not expressly approved by Hewlett-Packard could void the user's authority to operate this equipment.