Cleaning the printer:
During the printing process, paper, toner and dust particles can accumulate inside the printer. Over time, this buildup can cause print-quality problems such as toner specks or smearing. This printer has a cleaning mode that can correct and prevent these types of problems.
This printer has two processes for generating cleaning pages: one is automatically generated and another is manually generated. When a new black print cartridge is installed, a cleaning page will be automatically generated prior to calibration.
Cleaning the paper path:
The device features a special cleaning mode to clean the paper path.
Clean the paper path:
-
On the product control panel, press Setup.
-
Use the arrow buttons to select Service, and then press OK.
-
Use the arrow buttons to select Cleaning mode, and then press OK.
-
Load plain letter or A4 paper when prompted.
-
Press OK again to confirm and begin the cleaning process.
A page feeds through the printer slowly. Discard the page when the process is completed.
note:
Please run 3-4 cleaning pages in order to get better results.
Calibrating the printer:
Calibrations are performed at regular intervals. For best print quality, a calibration can be performed from the control panel using the following steps:
note:
This will calibrate the color and clean the black Image transfer belt (ITB). Perform 3 calibrations one after the other on the printer for better results.
-
On the product control panel, press Setup.
-
Use the arrow buttons to select System setup, and then press OK.
-
Use the arrow buttons to select Print Quality, and then press OK.
-
Use the arrow buttons to select Calibrate color, and then press OK.
-
Use the arrow buttons to select Calibrate now and press OK to perform the calibration.