hp-support-head-portlet

Actions
Loading...

Welcome to HP Customer Support

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...

hp-concentra-wrapper-portlet

Actions
Loading...

HP Designjet Color 3D Printer - Replacing material for single material bay

  1. From the display panel press Material... The display will show Add/Remove and S1(remaining%) and M1(remaining%). Asterisks will mark the currently active material bays (the material bays that are currently loaded to the head).
  2. Press Unload...
  3. Select Unload both, Unload Model or Unload Support.
  4. The printer will now unload material from the head. When the material has unloaded, you will need to replace the material carriers.
  5. Place the carrier on a flat stable surface.
      caution:
    Do not push the material through the material guide back into the carrier, doing so can cause material to break or become tangled.
  6. Open the carrier.
  7. Rotate the spool to rewind the material, leaving 2 inches (50mm) remaining at the material guide.
    Figure : Rewinding the material spool
  8. Using a cutters, cut the excess 2 inches (50mm) of material from the material guide. leaving a blunt end.
  9. Replace the material spool.
  10. Close and latch the carrier.
  11. Once the material carriers have been replaced press Load...
  12. Select Load Model, Load Support or Load both.
  13. After material has been loaded to the head press Done...

hp-feedback-input-portlet

Actions
Loading...

hp-online-communities-portlet

Actions
Loading...

Ask the community!


Support Forum

Support Forum

Join the conversation! Find Solutions, ask questions, and share advice with other HP product owners. Visit now


hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country: Flag United Kingdom

hp-detect-load-my-device-portlet

Actions
Loading...