HP Photosmart C4100 Series All-in-One - Installing Print Cartridges

Remarque :

The HP All-in-One must be powered on before you can insert the printcartridge.

1. Place the unit flat on a level surface.
2. Open the print cartridge door by lowering it until it stops. The print carriage moves to the far right side of the HP All-in-One.
   Figure : Print cartridge door and print carriage

   
3. Pull the pink tab to remove the tape from the print cartridge.
   Figure : Removing the pink tab

   

     Attention :

   Donot touch or remove the ink nozzles orcopper-colored contacts, or re-tape thecartridges.

   Figure : Do not touch ink nozzles or copper-colored contacts

   
4. Insert each print cartridge as follows:

   Remarque :

   • Insert the tri-color print cartridge in the slot on the left side, marked with a green label.
   • Insert the black (or photo) print cartridge in the slot on the right side, marked with a black and orange label.

   1. Hold the print cartridge with the HP label facingup.
   2. Push the print cartridge firmly into the corresponding slot until it snaps intoplace.
      Figure : Inserting the print cartridge

      
      Figure : Print cartridges properly installed

      
5. Close the access door.
   Figure : Access door being closed