HP Color LaserJet Enterprise M652, M653, Managed E65050, E65060, E65150, E65160 and HP Color LaserJet Enterprise MFP M681, M682, Managed MFP E67550, E67560, E67650, E67660 - Install accessory: Trusted platform module (TPM)
Learn how to install the trusted platform module (TPM).
Mean time to repair: 5 minutes
Service level: Basic
Important:
When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.
Before performing service
-
Turn the printer power off.
-
Disconnect the power cable.
Warning:To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts
|
Part numbers |
Part description |
|---|---|
|
F5S62-61001 |
Trusted platform module (TPM) |
Required tools
-
No special tools are needed to remove or install this assembly.
After performing service
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
Make sure that the printer initializes to a Ready state.
Print a configuration page to make sure that the printer is functioning correctly.
Remove the formatter cover
Follow these steps to remove the formatter cover.
-
Unscrew two thumbscrews (callout 1), and then slide the formatter cover (callout 2) away from the printer to remove it.
Tip:Reverse the removal steps to install the assembly.
Remove the formatter cover
Remove the TPM
Follow these steps to remove the TPM.
CAUTION:
ESD sensitive part.
ESD symbol
The TPM is available as an accessory for the M652/M653/M681/M682 models, and it is included as a standard component for the E65150/E65160/E67650/E67660 models. If your printer does not have a previously installed TPM, proceed to the next section.
-
Locate the TPM card on the formatter, and then pull it straight off of the formatter to remove it.
Remove the TPM
Remove the accessory from its package
Follow these steps to remove the accessory from its package.
-
Save all packaging for recycling.
-
For complete information about HP recycling programs, go to http://www8.hp.com/us/en/hp-information/environment/product-recycling.html.
Install the TPM
Follow these steps to install the TPM.
CAUTION:
ESD sensitive part.
-
Note the location on the formatter where the TPM will be installed.
TPM location
-
Align the connector on the TPM (callout 1) with the connector on the formatter (callout 2).
Note:The TPM can only be installed in one direction on the formatter.
Align the connectors
-
Push the TPM onto the formatter to install it.
Important:Press on the top part of the TPM to ensure it is fully seated in the connector.
Install the TPM
Install the formatter cover
Follow these steps to install the formatter cover.
-
Slide the formatter cover (callout 1) toward the printer to install it, and then tighten two thumbscrews (callout 2).
Install the formatter cover
Enter a topic to search our knowledge library
What can we help you with?
Need Help?