To view a video demonstrating the procedure for removing the part click here to access the Services Media Library (www.hp.com/go/sml). Select Printers and Multifunction under the Product category, select HP Color LaserJet Printers under the Product family, and then select the printer model under the product series category.
Memory replacement
You might want to add more memory to the product if you often print complex graphics, print PostScript
(PS) documents, or use many downloaded fonts. Added memory also gives you more flexibility in
supporting job-storage features, such as quick copying.
This product supports printing PDF files when 128 MB of memory is installed. However, for the best
performance, upgrade the memory to at least 192 MB.
note:Single inline memory modules (SIMMs) used in previous HP LaserJet products are not compatible with the product.
This product has one DIMM slot.
caution:Static electricity can damage DIMMs. When handling DIMMs, either wear an antistatic wrist strap or frequently touch the surface of the DIMM antistatic package, then touch bare metal on the product.
If you have not already done so, print a configuration page to find out how much memory is installed in
the product before adding more memory.
-
After the configuration page has printed, turn the product off and disconnect the power cord.
-
Disconnect all interface cables.
-
Remove the right-side panel by sliding it towards the rear of the product to unlatch it.
-
Open the access door by pulling on the metal tab.
-
Remove the DIMM from the antistatic package.
caution:
To reduce the possibility of damage caused by static electricity, always wear an electrostatic discharge (ESD) wrist strap or touch the surface of the antistatic package before handling DIMMs. -
Hold the DIMM by the edges, and align the notches on the DIMM with the DIMM slot. (Check that the locks on each side of the DIMM slot are open.)
-
Press the DIMM straight into the slot, and press firmly. Make sure the locks on each side of the DIMM snap into place.
note:
To remove a DIMM, first release the locks.
-
Close the access door, and press firmly until it snaps into place.
-
Reinstall the right-side panel. Align the tabs on the panel with the slots in the product, and push the panel toward the front of the product until it latches into place.
-
Reconnect the interface cables and the power cord.
-
Turn the product on.
