Error:

Javascript is disabled in this browser. This page requires Javascript. Modify your browser's settings to allow Javascript to execute. See your browser's documentation for specific instructions.

hp-support-head-portlet

Actions

دعم عملاء HP - قاعدة المعارف

hp-contact-secondary-navigation-portlet

Actions

hp-share-print-widget-portlet

Actions

ردود الفعل

hp-concentra-wrapper-portlet

Actions

HP LaserJet Pro M1130 and M1210 Multifunction Printer Series - Setting Up the LaserJet (Hardware)

Introduction

This document explains how to set up the physical parts of the product. Complete these steps before you install the product software on your computer.

This document includes the following steps to set up the printer:

Check the contents of the box
Remove packing tape
Prepare the print cartridge
Prepare the output bin
Load plain paper
Connect the power cord
Turn on power

Setting up the printer

Follow these steps in order.

Step one: Check the contents of the box

Remove the printer from the box, and then check the contents of the box.

The contents might vary by country/region. See the packaging for a list of items shipped in the box.

Step two: Remove packing tape

Remove all packing tape from the printer.

Step three: Prepare the print cartridge

Open the cartridge access door.

الشكل : Open the cartridge access door
Lift up the paper packing, but do not remove it.

الشكل : Lift the paper packing
Remove the print cartridge packaging.

الشكل : Remove the print cartridge packaging
Remove the print cartridge from the printer.

الشكل : Remove the print cartridge

إنذار:
To prevent damage to the print cartridge, hold the print cartridge at each end.
Remove the packaging from inside the printer.

الشكل : Remove the packaging from inside the printer
Remove the orange clip from the end of the print cartridge.

الشكل : Remove the orange clip from the print cartridge
Gently rock the print cartridge back and forth to distribute the toner evenly.

الشكل : Rock the print cartridge
Bend the tab on the left side of the print cartridge until the tab breaks loose. Pull the tab to remove all the sealing tape from the print cartridge.

الشكل : Remove the sealing tape

إنذار:
If toner gets on your clothing, wipe it off with a dry cloth and wash the clothing in cold water. Hot water sets toner into the fabric.
Insert the print cartridge, and then close the print cartridge door.

الشكل : Insert the print cartridge and close the door

Step four: Prepare the output bin

Insert the output bin extender into the output bin. The two clips on either side of the extender snap into place.

الشكل : Insert the output bin extender

Illustration: Insert the output bin extender.

Step five: Load plain paper

Load the paper face-up, top forward in the input tray.

الشكل : Load paper in the input tray
Slide the paper guides inward so that they rest against the stack of paper.

ملاحظة:
To prevent jams and skewing, always adjust the side and front paper guides.

الشكل : Adjust the paper guides