Learn about removing and replacing the fixed tray guide kit.
The procedure in this section shows Tray 2 in the figures. However, this procedure is also correct for Tray 3, Tray 4, or Tray 5.
Turn the printer power off
Disconnect the power cable.
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
If the part is damaged and cannot be cleaned, use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Part number |
Part description |
---|---|
5851-7708 |
Fixed tray guide kit with instruction guide
Note:
The kit includes four length guide locks, four width guide locks, and eight screws. Only one kit is required per printer. |
#2 Phillips screwdriver with a magnetic tip and a 152 mm 6 in shaft length
Turn the printer power on
Connect the power cable.
Use the power switch to turn the power on.
Print any pages necessary to make sure the printer is functioning correctly.
Learn about removing Tray 2.
A SFP printer is shown in this section. However, the procedure is correct for all printer models.
The figures in this section show Tray 2. However, this procedure is also correct for Tray 3, Tray 4, or Tray 5. Always carefully read the instructions that accompany the figures.
Learn about installing the fixed tray guide.