
hp-support-head-portlet

- ${title}
hp-contact-secondary-navigation-portlet

- ${title}
hp-share-print-widget-portlet

- ${title}
hp-concentra-wrapper-portlet

- ${title}
HP Color LaserJet Enterprise MFP M776 - Removal and replacement: Control panel (M776)
Learn how to remove and replace the control panel.

Mean time to repair: 7 minutes
Service level: CSR A
Before performing service
Turn the printer power off
-
Disconnect the power cable.
Warning:To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Part number |
Part description |
---|---|
J7Z09-67928 |
Control panel (M776dn/M776z/M776zs) |
Required tools
-
#2 Phillips screwdriver with a magnetic tip
After performing service
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
Make sure that the printer initializes to a Ready state.
Print a page to make sure that the printer is functioning correctly.
Remove the control panel (M776)
Follow these steps to remove the control panel (M776).
Unpack the replacement assembly
Follow these steps to unpack the replacement assembly.
Install the control panel (M776)
Follow these steps to install the control panel (M776).
hp-feedback-input-portlet

- ${title}
hp-feedback-banner-portlet

- ${title}
hp-country-locator-portlet

- ${title}
hp-detect-load-my-device-portlet

- ${title}
hp-hero-support-search

- ${title}