HP PageWide Enterprise Color 556, MFP 586 - Removal and replacement: Output bin

Follow these steps to remove the right cover (outer).

1. Pull out on the top corners of the right cover to release the top edge of the cover.

   Tip:

   Open the cartridge door to make removing the cover easier.

   Release the right cover (outer)

   

2. Slide the cover up and away from the printer to remove it.

   Remove the right cover (outer)

   

Follow these steps to remove the output bin.

1. Slightly slide the output bin to the right, and then lift up on it to remove it.

   Remove the output bin

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the output bin.

1. Position the replacement output bin on the printer. Align the tabs (callout 1) on the output bin with the slots (callout 2) in the top of the printer.

   Align the tabs and slots

   

2. Slide the output bin toward the printer to install it.

   Note:

   Make sure that the output bin is completely installed against the printer with no gaps in between.

   Install the output bin

   

Follow these steps to install the right cover (outer).

1. Position the bottom edge of the cover on the printer.

   Position the right cover (outer) on the printer

   

2. Push in along the top edge of the right cover (outer) to install it.

   Install the right cover (outer)