The BIOS password is used to protect BIOS settings from unwanted changes. If you have forgotten your password you may use this jumper to clear the password settings.
To erase the BIOS password follow these steps:
-
Turn OFF the computer and unplug the power cord.
-
In the default (normal) position the jumper is on pins 2-3.
-
Move the jumper to pins 1-2.
-
Wait approximately 10 seconds and then return the jumper to pins 2-3.
-
Plug in the power cord and turn ON the computer.
-
Hold down the F10 key during the startup process to enter BIOS
setup. You will not be asked for a password.