TITLE: Removing the Back Cover - c02205967
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


Before you actually start opening the PC to remove and replace the back cover, you will need to ensure the following:

* Remove any media (CD, DVD, and memory cards) from the computer.
* Turn off the computer and disconnect all cables. Be sure to disconnect the network cable before disconnecting the power cord.
* Transfer the computer to a clean, flat, stable work surface over a non-carpeted floor. HP recommends that you put down a blanket, towel, or other soft cloth to protect the screen from scratches or other damage.
* Electrostatic discharge (ESD) can damage your processor, disk drives, expansion boards and other components. Use an antistatic wrist strap and a conductive foam pad when working on the computer.
* Do not remove a component from its protective packaging until you are ready to install it.

CAUTION: This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a non-carpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

Let me know when you are ready to start.

Okay, now I will guide you through the steps to remove the back cover. To do so, follow the steps below:

WARNING: Make sure the computer is disconnected from power source before starting.

1. Remove the six screws securing the rear cover to the computer.

2. Pull up on the feet to release the cover.

3. Lift the cover off from the computer.

Let me know when the back cover is removed.