HP Kundensupport - Wissensdatenbank

hp-contact-secondary-navigation-portlet

Aktionen
Ladevorgang läuft...

hp-share-print-widget-portlet

Aktionen
Ladevorgang läuft...

hp-concentra-wrapper-portlet

Aktionen
Ladevorgang läuft...

HP EliteBook 8540w Mobile Workstation - Removing and Replacing the Optical drive

Introduction

This document is provided to assist in removing and replacing the optical drive for the HP EliteBook 8540w Mobile Workstation.

Minimum skill level

The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

Tools required

Small, Phillips-head P1 screwdriver

Parts required

Hinweis:
Part numbers are subject to change.
The replacement part number will vary depending on the optical drive that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP.
Description
Part Number
Requires Return
DVD+/-RW and CD-RW SuperMulti Double-Layer combination drive with LightScribe - SATA interface, 12.7 mm form factor - Includes bezel and bracket
595759-001 (Modified)
Yes
Blu-ray Disc (BD) SuperMulti double-layer DVD±R/RW optical drive - SATA interface, 12.7 mm tray load - Includes bezel
595760-001 (Modified)
Yes
DVD-ROM drive - SATA interface, 12.7 mm tray load - Includes bezel and bracket
595758-001 (Modified)
Yes
Blu-ray Disc (BD-R/RE) SuperMulti Double-Layer DVD±RW optical drive - SATA interface, 12.7 mm tray load - Includes bracket, bezel, and screws
595761-001 (Modified)
Yes
Hinweis:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

Summary of instructions

To view a video demonstrating the procedure for removing the optical drive, click on the link below. Or use the product video listing on the HP Services Media Library, (Click here to go to HP Service Media Library), then select Optical drive from the menu on the upper left hand side of the screen.
Click here to view the optical drive removal video (right-click on the link to open in a new window/tab).

Optical drive removal

  1. Review the safety considerations before performing the steps listed below by clicking on the following link:
      Vorsicht:
    Failure to comply with the precautions could result in damage to your product or loss of data.
  2. On the bottom of the notebook, loosen the captive P1 Phillips-head screw that secures the optical drive to the bottom of the base enclosure.
  3. Use a small, flat-bladed tool to push out on the metal tab on the rear of the optical drive to partially eject it from the base enclosure.
  4. Grasp the optical drive bezel and pull the optical drive out of the base enclosure.

Optical drive replacement

  1. Insert the optical drive into the base enclosure until its connector is firmly seated.
  2. Tighten the captive P1 Phillips-head screw that secures the optical drive to the bottom of the base enclosure.

Parts return



Land/Region: Flag Deutschland

hp-detect-load-my-device-portlet

Aktionen
Ladevorgang läuft...