This document provides the procedures to remove the toner collection unit.
Click the following link to view a video that demonstrates how to remove the toner collection unit:
Reverse the removal steps to install the assembly.
Before performing service
-
Disconnect the power cable.
advertencia:
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts
|
Toner collection unit part number
|
|
|
X3A60-67901
|
Toner collection unit
|
Required tools
-
No special tools are needed to remove or install this assembly.
After performing service
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
When the power is turned on, listen for normal startup sounds.
Check the control-panel display for error messages.
Make sure that the printer initializes to a Ready state.
Copy, scan, or print a document. Verify the document copies, scans, or prints correctly.
