hp-support-head-portlet

Actions
Chargement...
Assistance clientèle HP - Base de connaissances

hp-contact-secondary-navigation-portlet

Actions
Chargement...

hp-share-print-widget-portlet

Actions
Chargement...
  • Information
    Résoudre les problèmes de mises à jour de Windows 10

    Résoudre les problèmes de mise à jour de Windows 10 sur un PC HP – cliquez ici

    Information

    Problèmes de son ou de l’audio ? Essayez notre outil automatisé, HP Audio check!

    Information
    Créez votre compte HP dès aujourd’hui !

    Connectez-vous au site de support HP, gérez tous vos appareils en un seul endroit, affichez les informations de garantie et plus encore. En savoir plus

hp-concentra-wrapper-portlet

Actions
Chargement...

HP Officejet J5508 and J5520 All-in-Ones - Installing Print Cartridges

Introduction

This document provides information about installing and aligning print cartridges in the All-in-One.

Install the print cartridges

Use the following instructions to install and align print cartridges.

Step one: Install the print cartridge

Use the following steps to install the cartridges.
Remarque :
Leave the product turned on to install the cartridges.
  1. Open the cartridge door.
    The carriage moves to the far right side of the product.
    Figure : Open the cartridge door
  2. Remove the new cartridge from its packaging and, being careful to touch onlythe black plastic, gently remove the protective plastic tape.
      Figure : Remove protective tape
    1. Copper-colored contacts
    2. Plastic tape with pink pull tab (must be removed before installing)
    3. Ink nozzles under tape
      Attention :
    Do not touch the cartridge ink nozzles or copper contacts. Touching these parts will result in clogs, ink failure, and bad electrical connections.Do not remove the copper strips. They are required electrical contacts.
    Figure : Do not touch the ink nozzles or copper contacts.
  3. Slide each new cartridge forward into the empty slot. Gently push on theupper part of the cartridge forward until it clicks into the socket.
    • Insert the tri-color print cartridge into the left slot.
    • Insert the black print cartridge into the right slot.
      Figure : Insert cartridges
  4. Close the cartridge door.
    Figure : Close the cartridge door

Step two: Align the print cartridge

The product prompts you to align cartridges every time you install a cartridge. You can also align the cartridges at any time from the control panel, or by using the software you install with the product. Aligning the cartridges ensures high quality output.
  1. Make sure you have letter or A4 unused plain white paper loaded in the input tray.
  2. Press OK. The product prints an alignment page.
  3. Place the alignment page print-side down on the scanner glass.
  4. Press OK to scan the alignment page. When the scan finishes, the alignment is complete.
Remarque :
If you have colored paper loaded in the input tray when you align the cartridges, the alignment will fail. Load unused plain white paper into the input tray, and then try the alignment again.

hp-feedback-input-portlet

Actions
Chargement...

hp-feedback-banner-portlet

Actions
Chargement...

hp-country-locator-portlet

Actions
Chargement...
Pays/région : Flag Suisse

hp-detect-load-my-device-portlet

Actions
Chargement...