Error:

Javascript est désactivé dans ce navigateur. Javascript est requis pour cette page. Modifiez les paramètres de votre navigateur pour autoriser l'exécution de Javascript. Pour des instructions spécifiques, voir la documentation de votre navigateur.

hp-support-head-portlet

Actions

Chargement...

Assistance clientèle HP - Base de connaissances

hp-contact-secondary-navigation-portlet

Actions

Chargement...

hp-share-print-widget-portlet

Actions

Chargement...

Information

Avez-vous besoin d'aide avec Windows 11 ?
Vérifiez les informations sur la compatibilité, la mise à niveau et les correctifs disponibles auprès de HP et de Microsoft. Centre d'assistance Windows 11

Information

Problèmes de son ou de l’audio ? Essayez notre outil automatisé, HP Audio check!

Avis

hp-concentra-wrapper-portlet

Actions

Chargement...

Loading Paper and Envelopes for HP LaserJet Pro 200 Color MFP M276n and M276nw Printers

Introduction

This document describes how to load paper and envelopes into the printer.

Remarque :
To purchase paper in the United States and Canada, go to the HP Store.

Loading paper

Follow these steps to load paper.

Loading the paper input tray

Follow these steps to load paper into the paper input tray.

Pull out the paper input tray.

Figure : Pull out the paper input tray
Slide the paper guides to their outermost positions.

Figure : Slide out the paper guides

Remarque :
To load legal-size paper, extend the tray by pressing and holding the extension tab while pulling the front of the tray outward.

Figure : Extend tray for legal paper
Place the stack of paper print side up in the tray, and then make sure that the stack is flat at all four corners.
Slide the paper guides inward so that they rest against the stack of paper.

Figure : Slide the paper guides inward
Push down on the paper to make sure that the paper stack sits below the paper limit tabs on the sides of the tray.

Remarque :
The tray capacity is 150 sheets.

Figure : Push down on the paper
Slide the paper tray into the printer.

Figure : Insert the paper tray

Loading Envelopes

Envelope Guidelines

Do not use envelopes with clasps, snaps, windows, coated linings, self-stick adhesives, or other synthetic materials that are susceptible to heat.
Do not use envelopes that are wrinkled, nicked, stuck together, or otherwise damaged.
If you use envelopes with peel-off adhesive strips, make sure they are approved for use in laser printers.
Only use envelopes recommended for laser printers.
Use envelopes with seams that extend to the corners.
Acceptable

Unacceptable

Follow these steps to load envelopes into the paper input tray.

Pull the paper tray out of the printer.

Figure : Pull out the paper tray
Slide the paper guides to their outermost positions.

Figure : Slide out the paper guides
Remove any paper from the tray.
Load envelopes in the middle of the tray with the print side facing up and the stamp end in first.

Figure : Load envelopes this way

Remarque :
The tray capacity is 10 envelopes.
Slide the paper guides inward so that they rest against the envelopes.
Slide the paper input tray back into the printer.