hp-support-head-portlet

Actions
Chargement...
Assistance clientèle HP - Base de connaissances

hp-contact-secondary-navigation-portlet

Actions
Chargement...

hp-share-print-widget-portlet

Actions
Chargement...
  • Information
    Résoudre les problèmes de mises à jour de Windows 10

    Résoudre les problèmes de mise à jour de Windows 10 sur une imprimante ou un PC HP – cliquez ici

hp-concentra-wrapper-portlet

Actions
Chargement...

Removing and Replacing the Battery/Hard Disk Drive Cover for HP Envy 15-3000, 15-3100, 15-3200, and 15-3300 Notebook PCs

This document applies to HP Envy 15-3x00 series notebook computers.
HP Envy 15-3x00 series notebook computer

Before you begin

  • Turn off the computer. Disconnect the Ethernet or modem cable. Disconnect the power cord.
  • Transfer the computer to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
  • Do not remove a component from its protective packaging until you are ready to install it.
  Avertissement :
The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
  Avertissement :
Before starting, power off the computer and wait for components to cool before starting these procedures.
  Attention :
This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a non-carpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

Video overview

View the following video before using the steps in this article.
Remarque :
The video and graphics in this article depict a specific configuration of notebook computer. These same removal and replacement procedures apply to all configurations for all HP Envy 15-3x00 Series PCs.

Removing the cover

  Avertissement :
Make sure the computer is disconnected from power before starting.
Follow the steps in this section to remove the battery/hard disk drive cover.
Step 1
On the bottom of the notebook, slide the battery/hard disk drive release latch into the release position to partially eject the cover.
The release latch is identified by a battery icon.
Sliding the release latch
Step 2
Lift the battery/hard disk drive cover off of the computer.
Lifting the cover

Replacing the cover

Use the steps in this section to replace the battery/hard disk drive cover.
Step 1
Align the battery/hard disk cover on the computer.
Aligning the cover
Step 2
Slide the battery/hard disk drive cover towards the rear of the computer until it is properly seated and the release latch clicks.
Sliding the cover

hp-feedback-input-portlet

Actions
Chargement...

hp-feedback-banner-portlet

Actions
Chargement...

hp-country-locator-portlet

Actions
Chargement...
Pays/région : Flag Canada - Français

hp-detect-load-my-device-portlet

Actions
Chargement...