OMEN by HP GA1-1000 Accelerator - Setting Up the OMEN Graphics Accelerator

Install a full or half-length graphics card to enhance your gaming experience.

1. To open the access panel, pull up on the release latch, and then lift the access panel.

   

2. Insert the graphics card into the PCI slot.

   

3. Secure the card in place.

   • Full-length card: Place the bracket on the card, and then install the screws to secure the bracket and card in place.

   • Half-length card: Install the screw to secure the card in place.

4. Plug in the power cord, and then close the access panel.

   

Update the firmware, software, and drivers for you computer before you use the OMEN by HP GA1-1000 Accelerator.

1. Make sure your computer is using AC power and has an active internet connection.

2. Download and install the latest graphics driver from the manufacturer's website:

   • AMD

   • NVIDIA

3. Update the BIOS on your computer. For detailed steps, go to:

   • Desktops: HP Consumer Desktop PCs - Updating the BIOS (Basic Input Output System) (Windows)

   • Notebooks: HP Consumer Notebook PCs - Updating the BIOS (Basic Input Output System) (Windows)

4. Restart your computer if it does not restart automatically.

5. After the computer restarts, download and install the latest Intel Thunderbolt packages:

   • Intel Thunderbolt Firmware Update

   • Intel Thunderbolt Controller Driver

6. Connect the OMEN Accelerator to the Thunderbolt 3 port on your computer.

7. With the accelerator connected, download and install the latest OMEN Accelerator drivers:

   • OMEN Accelerator Firmware Update

   • OMEN Accelerator app

   • Realtek LAN driver

Install an internal hard drive in the OMEN Accelerator.

1. To open the access panel, pull up on the release latch, and then lift the access panel.

   

2. Remove the hard drive from its packaging.

3. While grasping the hard drive in one hand, lower the hard drive into the hard drive tray, and then install the screws.

   

4. Insert the hard drive tray into the drive bay, pushing the tray toward the rear of the accelerator shell until it clicks into place.

   

5. Tighten the screw, and then connect the cable to the rear of the hard drive.

   

6. Close the access panel.

Use the OMEN Accelerator app to switch between graphics cards, view the use of network resources, and change settings.

1. Open the OMEN Accelerator app.

   If you are opening the app for the first time, a welcome screen displays with explanations of the features and functions of the app.

2. Choose a feature depending on what you want to do.

   • Graphics Switcher: Switch between graphics cards, set the app to open automatically, or switch graphic processors automatically when you connect the OMEN Accelerator.

   • Network Booster: View or change network service priorities for the different apps running on the computer.

Properly disconnect the OMEN Accelerator to avoid any loss of data or other issues.

1. On your computer, click the Thunderbolt icon in the system tray display or menu.

2. Select Eject OMEN Accelerator.

3. Disconnect the accelerator after the Safe to remove hardware message displays.