HP LaserJet M605, M606 - Removal and replacement: Control panel (M605x, M606x)

Follow these steps to remove the control panel.

1. Tilt the control panel up.

   Tilt the control panel up

   

2. Before proceeding, take note of the location of the tabs (callout 1) on the control-panel screws cover. Use a small flat-blade screwdriver to release these tabs at the top of the cover.

   Release tabs

   

3. Rotate the cover away from the control panel base to remove it.

   Rotate cover away

   

4. Remove two screws (callout 1).

   Remove two screws

   

5. Rotate the control-panel base toward the front of the printer.

   Rotate the control panel base

   

6. Disconnect one USB cable (callout 1), and one connector (callout 2).

   Disconnect connectors

   

7. Remove the control panel.

   Remove the control panel

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the control panel.

1. Open the replacement control panel, and then position the tabs (callout 1) on the control panel in the slots (callout 2) in the printer.

   Reinstall the control panel

   

2. Connect one USB cable (callout 1), and one connector (callout 2).

   Connect connectors

   

3. Rotate the control-panel base down onto the printer.

   Rotate the control-panel base down

   

4. Install two screws (callout 1).

   Install two screws

   

5. Position the screw cover mounting feet into the slots in the top cover (callout 1), and then rotate the cover toward the control-panel base (callout 2) to install it.

   Note:

   Make sure that the tabs on the cover (callout 3) snap into place.

   Install screw cover