HP LaserJet Pro MFP M435nw - Load Tray 1 (multipurpose tray)

note:

Tray 1 holds up to 100 sheets of paper, up to 75 transparencies, up to 50 sheets of labels, or up to 10 envelopes. It supports cut sheet paper weight 60–199 g/m2; labels and transparencies 0.10 to 0.14 mm thick; envelopes weight 60 to 90 g/m2; and postcards weight 135 to 176 g/m2.

For information about the correct paper orientation for loading paper in this tray, see Tray 1 paper orientation.

1. Open Tray 1 by grasping the handles on each side of the tray and pulling down.
   Figure : Open the tray
   
2. Slide out the tray extension.
   Figure : Slide out the extension
   
3. For long paper, fold out the tray extension to support the paper.
   Figure : Fold out the extension
   
4. Open the paper guides.
   Figure : Open the paper guides
   
5. Load the paper into the tray. Make sure that the paper fits under the tabs and below the maximum-height indicators.
   The way you should orient the paper in the tray varies depending on the paper size. For additional information, see Tray 1 paper orientation.
   Figure : Load paper in the tray
   
6. Adjust the paper guides so that they lightly touch the paper stack but do not bend the paper.
   Figure : Adjust the guides
   

note:

To avoid jams, do not add paper to Tray 1 while the product is printing. Do not close Tray 1 while the product is printing.