hp-support-head-portlet

Actions
Loading...

Welcome to HP Customer Support

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    Looking for Site Help?

    Learn about the features of the HP Customer Support site and how to use them to meet your online support needs. Click Here

     

hp-concentra-wrapper-portlet

Actions
Loading...

HP Compaq dx2400 Microtower PC - Removing and Replacing Access Panel

Introduction
This document is provided to assist in removing and replacing the Access panel for the HP Compaq dx2400 Microtower PC.
Minimum skill level
The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.
Tools required
  • T-15 Torx screwdriver
Parts required
  note:
Part numbers are subject to change.
The replacement part number will vary depending on the Access panel that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP.
Description
Part Number
Requires Return
Access panel
464597-001 (Modified)
No
  note:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If the unit contains a part that is labeled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If the unit contains a part that is labeled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.
Summary of instructions
To view a video demonstrating the procedure for removing the Access panel, click on the link below. Or use the product video listing on the HP Services Media Library, then select Access panel from the menu on the upper left hand side of the screen.
Right-click on the link to open in a new window/tab.
Access panel removal
  note:
Remove the cable lock or padlock from the back of the chassis, if either one is installed.
  1. Review the safety considerations before performing the steps listed below by clicking on the following link:
      caution:
    Failure to comply with the precautions could result in damage to the product or loss of data.
  2. Loosen the captive Torx-15 screw that secures the access panel.
  3. Use the handle to slide the panel back about half an inch.
  4. Lift the panel off the chassis.
Access panel replacement
  1. Place the access panel on the bottom chassis guide rail.
  2. Rotate the panel up and align the tabs on the panel with the slots on the chassis guide rails.
  3. Press the access panel against the chassis and slide it forward until it is flush with the front bezel.
  4. Tighten the captive Torx-15 screw.

hp-feedback-input-portlet

Actions
Loading...

hp-online-communities-portlet

Actions
Loading...

Ask the community!


Support Forum

Support Forum

Join the conversation! Find Solutions, ask questions, and share advice with other HP product owners. Visit now


hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country: Flag Canada

hp-detect-load-my-device-portlet

Actions
Loading...