The BIOS password is used to protect BIOS settings from unwanted changes. If you have forgotten your password you may use this jumper to clear the password settings.
To clear the BIOS password follow these steps:
-
Turn OFF the computer and unplug the power cord.
-
Locate the jumper labeled CLR_PASSWD.
-
Use a jumper cap to bridge pins 3-4.
-
Wait approximately 10 seconds and then remove the jumper cap.
-
Plug in the power cord and turn ON the computer.
-
Hold down the F10 key during the boot process to enter BIOS setup. You will not be asked for a password.