
hp-support-head-portlet

- ${title}
hp-contact-secondary-navigation-portlet

- ${title}
hp-share-print-widget-portlet

- ${title}
hp-concentra-wrapper-portlet

- ${title}
HP LaserJet MFP M72625 and MFP M72630 - Removal and replacement: Toner collection unit
Learn how to remove and replace the toner collection unit.
Introduction

Before performing service
Turn the printer power off
-
Disconnect the power cable.
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Part number |
Part description |
---|---|
X3A60-67901 |
Toner collection unit |
Required tools
-
No special tools are needed to remove or install this assembly.
After performing service
Turn the printer power off
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
After replacing major assemblies (for example, the document feeder) or internal parts (for example, the formatter board), perform the following post service tests.
-
When the power is turned on, listen for normal startup sounds.
-
Check the control-panel display for error messages.
-
Make sure that the printer initializes to a Ready state.
-
Copy, scan, or print a document. Verify the document copies, scans, or prints correctly
Remove the TCU
Follow these steps to remove the TCU.
hp-feedback-input-portlet

- ${title}
hp-feedback-banner-portlet

- ${title}
hp-country-locator-portlet

- ${title}

hp-detect-load-my-device-portlet

- ${title}
hp-hero-support-search

- ${title}