hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    We are upgrading our website

    If you experience errors during this time, please try again later. 

hp-concentra-wrapper-portlet

Actions
Loading...

HP Compaq nc4400 Notebook PC - Removing and Replacing the Fan

Introduction

This document is provided to assist in removing and replacing the Fan for the HP Compaq nc4400 Notebook PC.

Minimum skill level

The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

Tools required

Small, Phillips-head (P0,P1) screwdrivers.
Small, flat-bladed screwdriver or a flat-bladed alignment tool.
Torx 8 (T8) screwdriver.

Parts required

note:
Part numbers are subject to change.
The replacement part number will vary depending on the Fan that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP.
Description
Part Number
Requires Return
Cooling fan
419127-001 (Modified)
Yes
note:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labeled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labeled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

Summary of instructions

To view a video demonstrating the procedure for removing the Fan, click on the link below. Or use the product video listing on the (Click here to go to HP Service Media Library), then select Fan from the menu on the upper left hand side of the screen.
Click here to view the Fan removal video (right-click on the link to open in a new window/tab).

Fan removal

  1. Review the safety considerations before performing the steps listed below by clicking on the following link:
      caution:
    Failure to comply with the precautions could result in damage to your product or loss of data.
  2. Disconnect the fan cable from the system board.
  3. Remove the three T8-7 mm screws that secure the fan to the base enclosure.
  4. Lift and remove the fan.

Fan replacement

  1. Place the fan into the base enclosure.
  2. Replace the three T8-7 mm screws that secure the fan to the base enclosure.
  3. Reconnect the fan cable to the system board.

Parts return


hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag Bulgaria

hp-detect-load-my-device-portlet

Actions
Loading...