This document explains how to set up the physical parts of the product. Complete these steps before you install the product software on your computer.
- Support Home
- Software and Drivers
- Contact Us
- Business Support
- My HP Account
note:USB cables are not included with new printers. To order optional accessories such as USB cables, click the 'How to Buy' link on this page to purchase the accessory. If the accessory is not available from HP, there are many resellers that carry HP-compatible accessories.
note:The power cord is either in a separate packet with the product or it inside the paper tray along with the cartridges.
caution:Make sure that the HP product is idle and silent when loading paper into the main input tray. If the HP product is servicing the cartridges or otherwise engaged in a task, the paper stop inside the device might not be in place. If the paper is too far forward, the HP product might eject blank pages.
note:Do not overload the input tray. Make sure the stack of paper fits within the input tray and is no higher than the top of the paper-width guide.
caution:The product must be on to release the cartridges. Trying to remove the cartridges while the product is off might damage the product.
note:Make sure that the carriage moves to the center of the product. If the carriage does not move to the center, turn the product off and then turn it back on again.
caution:Do not touch the copper-colored contacts or ink nozzles. Contact with these parts can result in clogs, ink failure, and bad electrical connections.Figure : Copper-colored contacts