This document pertains only to HP EliteBook 8470p Notebook PC with the following case design:

note:Part numbers are subject to change.
Description
|
Part Number
|
Requires Return
|
8GB 1600-MHz PC3-12800 memory module (SHARED)
|
670034-001
|
Yes
|
SPS-MEM 4GB PC3-12800 DDR3 LOCKED
|
707248-001
|
Yes
|
4GB 1600MHz PC3-12800 memory module (SHARED)
|
641369-001
|
Yes
|
2GB 1600MHz PC3-12800 memory module (SHARED)
|
652972-001
|
Yes
|
note:For customers in countries/regions with RoHS legislation (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the "Original" spare part is regulated by RoHS legislation. If the unit contains a part that is labeled with the "Modified" spare number, the "Modified" spare part must be ordered as the replacement part. If the unit contains a part that is labeled with the "Original" spare number, please order the "Original" spare number as the replacement part. In this case, either the "Original" or the "Modified" spare number may be shipped which will not affect performance or functionality of the unit.
caution:Failure to comply with the precautions could result in damage to the product or loss of data.
note:The primary and expansion memory slots are both located under the bottom cover. The primary memory slot is located on the bottom and the expansion memory slot is located on top. If an expansion memory board is installed, it must be removed before the primary memory board can be removed.
Step
|
Procedure
|
Instruction
|
1
|
Remove the battery.
| |
2
|
Remove the bottom door.
| |
3
|
Push both arms outward simultaneously to release the memory module to the spring tension position.
|
![]() |
caution: |
||
4
|
Grasp the memory board by the edges and pull gently to remove it and place the memory board in a static dissipative bag.
|
![]() |
Steps
|
Procedure
|
Instruction
|
1
|
Grasp the memory module by the edges from the static dissipative bag and align the notch in the memory module with the key in the memory module slot on the system board
|
![]() |
2
|
At an angle, gently insert the memory module into its slot on the system board.
|
![]() |
caution: |
||
3
|
Press the memory board down to latch the arms.
|
![]() |
4
|
Replace the bottom door.
| |
5
|
Replace the battery.
|