-
The First Transfer wizard uses a job which consists of nine sheets with two separations each. The
PIP to ITM pressure increases from one sheet to the next.
-
The job image consists of two columns with six triangles each. Each column is equivalent to a
different side of the drum.
During the calibration procedure:
-
Identify the sheet number with at least three triangles in a column.
-
Triangle fragments count as a triangle.
-
Spread 5 is the first one to print 3 triangles in the left column.
-
Spread 6 is the first to print in the right column.
-
On the touch screen, click the Main Menu, Blanket and PIP, and First Transfer. The First Transfer
wizard opens.
-
Follow the instructions in the wizard:
-
Enter the sheet number (printed on the triangles) in the correct column.
-
In the First Transfer Calibration, enter the print number in the correct column. The print number
appears in each triangle.
-
If you cannot identify three triangles in a column in any of the nine prints, click 9, and then
Next and Finish.
-
Restart this procedure at step 1.
-
If three triangles appear in all nine prints, click 1, and then Next and Finish. Restart this
procedure at step 1.
Figure : Spread 4 (incorrect front pressure)
Figure : Spread 5 (correct front pressure)
Figure : Spread 6 (correct rear pressure)
Figure : Spread 7 (too much pressure)
