hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...

hp-concentra-wrapper-portlet

Actions
Loading...

HP Compaq dc7800 Small Form Factor PC - Removing and Replacing the RTC battery

This document pertains only to HP Compaq dc7800 Small Form Factor PCs with the following case design:

Before you begin

  • You need a wooden or plastic flat-bladed tool.
  • Turn off the computer, and then disconnect all cables. Disconnect the Ethernet or modem cable before disconnecting the power cord.
  • Move the computer to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
  • Do not remove a component from its protective packaging until you are ready to install it.
  warning:
The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
  caution:
This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

Video overview (in English)

To view a video demonstrating the procedure for removing the RTC battery, right-click RTC battery removal video and select Open link in new window/tab.

Replacement part information

The following HP part numbers are known to be compatible with this system:
note:
Part numbers are subject to change.
Description
Part Number
Requires Return
3.0 V battery (CR2032) - Lithium disc cell 220 mAh, 20 mm diameter, 3.2 mm height
153099-001 (Modified)
No
* If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. For more information about returning parts to HP select one of the links below:
note:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

RTC battery removal

  caution:
Review the following safety considerations before performing the following steps. Failure to comply with these safety considerations could result in damage to the product.
Step 1
With all cables disconnected from the computer, remove the access panel.
Step 2
Rotate the power supply to the up position.
Step 3
Press the locking clip with a flat-bladed tool to release the battery.
Step 4
Lift the battery out of the socket.

RTC battery replacement

Step 1
Press the battery into the socket with the plus (+) sign facing up.
Step 2
Rotate the power supply to the down position.
Step 3
Replace the access panel.

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag Australia

hp-detect-load-my-device-portlet

Actions
Loading...