HP LaserJet Pro 200 Color MFP M276 - Paper Jam Error

  caution:

Do not use sharp objects, such as tweezers or needle-nose pliers, to remove jams. Damage caused by sharp objects are not covered by the warranty.

1. Turn off the printer.
2. If paper is visible in the output bin, grasp the leading edge, and with both hands, carefully pulling it free from the printer.
   
3. Turn on the printer.

1. Turn off the printer, and then disconnect the power cord from the rear of the printer.

     warning:

   To avoid risk of injuries or electric shock, you must disconnect the power cord before you reach inside the printer.

2. Remove any loose paper from the ADF input tray that has not fed into the printer.
3. Remove any jammed paper visible in the input tray area. To avoid tearing any whole sheets of paper, pull the paper with both hands.
   
4. Lift the ADF input tray.
   
5. Place your thumb under the tab on the end of the jam-access cover, and then lift the jam-access cover.
   
6. Gently pull out any jammed paper from the ADF. To avoid tearing any whole sheets of paper, pull the paper with both hands.
   
7. If the paper tears while you remove it, check the rollers and wheels for any torn pieces of paper that might remain inside the ADF. Use a flashlight to thoroughly look for torn pieces of paper. If any torn pieces of paper remain inside the printer, more paper jams might occur.
8. Close the jam-access cover.
   
9. Close the ADF input tray.
   

1. Lift the scanner assembly.
   
2. With the printer turned on, disconnect the power cord from the rear of the printer, and then open the top cover.

     warning:

   To avoid risk of injuries or electric shock, you much disconnect the power cord before you reach inside the printer.

   
3. Remove the toner cartridge.
   
4. Remove any jammed paper from the toner cartridge area. Use both hands to remove jammed paper to avoid tearing the paper.
   
5. If the paper tears while you remove it, check the rollers and wheels for any torn pieces of paper that might remain inside the ADF. Use a flashlight to thoroughly look for torn pieces of paper. If any torn pieces of paper remain inside the printer, more paper jams might occur.
6. Reinsert the toner cartridge.
   
7. Close the top cover.
   
8. Lower the scanner assembly.
   
9. Reconnect the power cord to the rear of the printer, and then turn on the printer.
10. If the error message still displays on the control panel, touch OK to clear it.

1. Open the rear access door.
   
2. Turn off the printer, and then disconnect the power cord from the rear of the printer.

     warning:

   To avoid risk of injuries or electric shock, you must disconnect the power cord before you reach inside the printer.

3. Use both hands to remove jammed paper to avoid tearing the paper.
   
4. If the paper tears while you remove it, check the rollers and wheels for any torn pieces of paper that might remain inside the ADF. Use a flashlight to thoroughly look for torn pieces of paper. If any torn pieces of paper remain inside the printer, more paper jams might occur.
5. Close the rear access door.
   
6. Reconnect the power cord to the rear of the printer, and then turn on the printer.
7. If the error message still displays on the control panel, touch OK to clear it.

1. Open the rear door.

     caution:

   The fuser is located above the rear door, and it is hot. Do not attempt to reach into the area above the rear door until the fuser is cool.

   
2. With both hands, grasp the paper, and carefully pull it free from the printer.

   note:

   If the sheet tears, remove all fragments before you continue. Do not use sharp objects to remove fragments.

   

3. Once jammed paper has been removed, close the rear door.
   Figure : Close the rear door