hp-support-head-portlet

Actions
Loading...

HP Customer Support

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Alert
    Need help after upgrading to Windows 10?

    Here are solutions to common problems seen after upgrading.

    View article

hp-concentra-wrapper-portlet

Actions
Loading...

Removing and Replacing the CD/DVD Drive for HP Pavilion dv6-7000, dv6-7100 and HP ENVY dv6-7200, dv6-7300 Notebook PCs

This document applies to HP Pavilion dv6-7x00 series and HP ENVY dv6-7x00 series notebook computers.
HP dv6-7x00 series notebook computer
Before you begin
  • You need a Phillips head screwdriver.
  • Turn off the computer. Disconnect the Ethernet or modem cable. Disconnect the power cord.
  • Transfer the computer to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
  • Do not remove a component from its protective packaging until you are ready to install it.
 warning:
The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
 warning:
Before starting, power off the computer and wait for components to cool before starting these procedures.
 caution:
This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.
Video overview
View the following video before using the steps in this article.
Removing the CD/DVD drive
 warning:
Make sure the computer is disconnected from power before starting.
Follow the steps in this section to remove the CD/DVD drive.
Step 1
Remove the battery.
For more information about removing the battery, refer to the HP support document Removing and Replacing the Battery.
Removing the battery
Step 2
Remove the service door.
For more information about removing the service door, refer to the HP support document Removing and Replacing the Service Door.
Removing the service door
Step 3
Remove the screw that secures the CD/DVD drive to the computer.
CD/DVD drive screw
Step 4
Using a small, non-metallic tool, press on the rear edge of the CD/DVD drive to free the CD/DVD drive from its connector.
Pushing out the CD/DVD drive
Step 5
Remove the CD/DVD drive.
Removing the CD/DVD drive
Replacing the CD/DVD drive
Use the steps in this section to replace the CD/DVD drive.
Step 1
Insert the CD/DVD drive into the CD/DVD drive bay until the connector is fully seated.
Inserting the CD/DVD drive
Step 2
Replace the CD/DVD drive screw.
CD/DVD drive screw
Step 3
Replace the service door.
For more information about replacing the service door, refer to the HP support document Removing and Replacing the Service Door.
Sliding the service door in
Step 4
Replace the battery.
For more information about replacing the battery, refer to the HP support document Removing and Replacing the Battery.
Pressing down on the battery

hp-feedback-input-portlet

Actions
Loading...

hp-online-communities-portlet

Actions
Loading...

Ask the community!


Support Forum

Support Forum

Join the conversation! Find Solutions, ask questions, and share advice with other HP product owners. Visit now


hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
United States

hp-detect-load-my-device-portlet

Actions
Loading...