HP Deskjet D5560 and D5568 Printers - Wireless Connection Using One Button Wireless Setup with a WPS Enabled Router
This document contains steps to connect the HP product to a wireless network using One Button Wireless Setup with a Wi-Fi Protected Setup (WPS)-enabled router.
Wireless connection using One Button Wireless Setup with a WPS enabled router
Follow these steps to establish a wireless connection.
Step one: Verify required components
Make sure you have the following items before continuing with wireless setup:
A wireless 802.11 network that includes a WPS-enabled wireless router or access point
A computer with either wireless networking support, or a network interface card (NIC)
The computer must be connected to the wireless network that you intend to install the HP product on
Step two: Establish the connection
Press and hold the Wireless button () for two seconds.
Press the corresponding button on the WPS-enabled router or other networking device. If you do not know what the corresponding button on your router is, contact the manufacturer of the router.
note:You have two minutes to press the corresponding router button.The Wireless icon () and signal-strength bar () appear solid to indicate successful wireless network configuration.Figure : Wireless icon and signal-strength bar: Wireless configuration successful
Ask the community!