HP Support

hp-contact-secondary-navigation

Actions
Loading...

hp-share-print-widget

Actions
Loading...

hp-concentra-wrapper

Actions
Loading...

Adding or Replacing a CD/DVD Drive in HP Pavilion a1000, t3000 Series Desktop PCs

This document only pertains to HP Pavilion desktop PCs with the following PC case:
Before you begin
  • Turn off the PC, disconnect all cables, and transfer the PC to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the PC.
 warning:
The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
 caution:
This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.
Video overview
View the following video before using the steps in this article.
 note:
For best quality on dial-up connections, wait until the video has fully loaded before viewing.
Removing a CD or DVD drive
Use the steps in this section to remove a CD or DVD drive so that an empty bay can be used to install a new drive.
 warning:
Make sure the computer is disconnected from power before starting.
Step 1. To remove either the lower or upper optical drive, remove both the right and left side panel and the front cover.
For more information about removing the side panels and the front cover, refer to the HP support documents Opening the PC Case and Removing the Front Cover.
Step 2. Remove the power and flat ribbon cables from the rear of the drive that you want to remove.
Step 3. Pull on the quick release latch for each CD or DVD drive that is installed.
Step 4. While holding the release latch, pull the drive out through the front of the PC.
Installing a CD or DVD drive
Use the steps in this section to install a new CD or DVD into an empty drive bay.
Step 1. Attach four screws, two on each side, to the new drive.
You can use the screws from the drive that was removed or additional screws can be found on the front of the PC.
Step 2. Make sure that the new drive is set to Cable Select.
Step 3. Align the screws on the side of the drive into the guides on the chassis...
...and slide the drive into the PC until it locks into place
Step 4. Attach the power and flat ribbon cables to the rear of the drive.
 note:
If you have installed a new drive in an empty optical drive bay, connect the flat ribbon cable marked SLAVE to the new drive.
Step 5. Replace the side panels and the front cover, reconnect the cables, and turn on the PC.
For more information about replacing the side panels and the front cover, refer to the HP support documents Opening the PC Case and Removing the Front Cover.
Step 6. If using Windows, wait until Windows fully opens, finds, and configures the new drive.

hp-online-communities

Actions
Loading...
Consumer Community

Consumer Community

Join the conversation! Find Solutions, ask questions, and share advice with other HP product owners. Visit now >

Enterprise Business Community

Enterprise Business Community

Join HP's community of business and IT professionals to help solve problems, exchange ideas, and learn best practices from your peers. Worldwide discussions in English. Visit now >


Contact HP

Contact HP

Let HP help you find the answer or identify a service location. Contact us >

Country: United States