hp-support-head-portlet

Actions
Loading...

HP Customer Support

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...

hp-concentra-wrapper-portlet

Actions
Loading...

HP Jornada 560 Series PDA - Setting Up and Using the Jornada Battery Pack with MMC Slot

Introduction
This document describes setting up and using the accessory HP Jornada 560 Battery Pack with MMC Slot (referred to in this document as “the battery”).
Set up
Complete the following steps to set up the battery:
  1. Insert the CD into your CD-ROM drive.
     note:
    HP strongly recommends installing the drivers into the default installation directory or the main memory of your HP Jornada 560 to ensure that the MMC slot on the battery functions properly.
  2. Follow the on-screen instructions to install the necessary drivers onto your HP Jornada.
  3. Ensure you have sufficient power in the backup battery. To check the backup battery:
    1. Tap Start then Settings.
    2. Tap the System tab.
    3. Tap the Power icon.
    4. Verify that the backup battery shows as Good.
  4. Replace the backup battery if it shows as Low or Very Low.
  5. Remove the old battery by unlocking the main battery lock (see A in Figure 1) and sliding the battery out of the main battery slot (see B in Figure 1).
    Figure : Removing the old battery
  6. Insert the new battery (see Figure 2).
  7. Insert the MMC card into the MMC slot (see Figure 2).
    Figure : Installing the new battery and MMC card

hp-feedback-input-portlet

Actions
Loading...

hp-online-communities-portlet

Actions
Loading...

Ask the community!


Support Forum

Support Forum

Join the conversation! Find Solutions, ask questions, and share advice with other HP product owners. Visit now


hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country: Flag United States

hp-detect-load-my-device-portlet

Actions
Loading...