The optional Rollfeed accessory is composed of three main modules: right and left roll supports, and a spindle. The Rollfeed is designed to provide a controlled tension to the paper in order to avoid misalignment and unwinding the media.
The purpose of this separate product is to support operation of the HP Designjet 400 series printer with roll media in order to meet the following objectives:
-
Able to work both on a tabletop and a printer stand
-
Easy to install
-
Easy to use, able to be left unattended, and generally able to finish the roll without any extra alignment required
-
No PQ degradation in respect to single-sheet operation
-
Same success rate in single-sheet media load as without Rollfeed installed
-
Low cost
-
Medias supported: All the roll media supported by HP Designjet 400 series printers.
note:
Click here to access on-line up to date media information. (The link is http://www.hp.com/sbso/product/supplies/landing.html) -
Roll core diameter: standard core from USA and EU. There will also be an adaptable hub to use the approximately 30 mm core diameter Asian media.