HP Designjet 330/350C Printers - Loading Roll Media
Loading Roll media on the HP DesignJet 330 and 350C printers.
Follow the steps below:
Turn on the printer; the Load Media light should be on solid.
Select the Media Type option and press the Roll/sheet button until the Roll light comes on.
Load the media and the Ready light will stop flashing (this may take a minute).
The Load Media light should start to flash. Raise the cover and the bail should lift automatically.
Pull and align the media and push the lever back once media is correctly aligned; the bail should lower. The Media light will continue to flash. After the paper stops moving, trim the edge with the paper cutter.
Close the cover and the Ready light will flash. When the Ready light stops flashing, the printer is ready to plot.
Ask the community!